2 months ago

Control a motor with the AIY projects Voice HAT

In our recent AIY Projects tutorials, we’ve looked at how to move beyond using the Voice Assistant, and towards using your Voice HAT with basic electronics.

If you’ve been following our tutorials, you will have discovered how to connect the Voice HAT hardware to simple circuits. So far we’ve looked at how to control LED lights and servo motors, but in this tutorial we’ll look at something a little more complex: using the AIY Projects Voice HAT to control a motor.

You’ll need

  • DC motor
  • 4×AA battery pack
  • Breadboard and jumper wires
  • Utility/Stanley knife

STEP-01 Cut the power

The first thing you need to do is isolate the Raspberry Pi’s power supply from the power on the Voice HAT board. This will prevent the DC motor from draining too much power and shorting out your Raspberry Pi. Locate the external power solder jumper marked JP1 (just to the left of Servos 5 on the Voice HAT board). Use a utility knife to cut the connection in the jumper (you can always re-solder this joint if you wish to share the power between the board and the motor again).

STEP-02 Power off

Make sure your Raspberry Pi and Voice HAT board are powered off. Now connect the positive leg of the DC motor to the middle pin on Drivers 0. Notice that at the bottom of the Driver pins is a ‘+’ symbol.

STEP-03 Wire for power

Next, connect the negative wire of the motor to the ‘-’ pin on Drivers 0 (the pin on the right). You may have noticed that we’re not connected to the GPIO Pin on the left (which is GPIO4); this doesn’t matter as it also controls the negative ‘-’ pin that we have just connected to. This allows us to turn the motor on and off.

STEP-04 Power up

Finally, connect the 4×AA battery pack to the +Volts and GND pins at the lower left-hand corner of the Voice HAT. This pack will ensure that the motor has enough power when you are using the Voice HAT, which will prevent your Raspberry Pi from crashing. Connect the power and turn on the battery pack.

STEP-05 Turn on the Pi

Now turn on the Raspberry Pi and boot into the AIY Projects software. Enter the code from motor.py to test the circuit. We are using PWMOutputDevice from GPIO Zero to control the motor. This enables us to manage the speed of the motor. We can use the .on() and .off() methods to start and stop our motor. Alternatively, we can set the value instance variable to a value between 0.0 and 1.0 to control the speed. Both techniques are shown in the motor.py code. You can also use pwm.pulse() to pulse the motor on and off.

STEP-06 Hook it up to the Voice Assistant

Now that we’ve seen how to control the motor using GPIO Zero, it is time to integrate it with the Voice Assistant. Enter the code from add_to_action.py to the relevant sections of
/home/pi/voice-recognizer-raspi/src/action.py and run src/main.py. Push the button on your Voice HAT board and say “motor on” to start the motor running; push the button again and say “motor off” to stop it.

Code listing



  • wadael

    no diode between motor and hat to protect the hat ?

  • I don’t know.

  • Anders Jackson

    Have to look at the board or schema to know if there are a need for a diod across the motor poles.

  • Mika Gouzee

    Could you provide pictures with these kind of articles? Would help 🙂

  • William Woodard

    How would you make motor go backwards.