Quick Start Guide

What you will need


  • SD Card
  • Display and connectivity cables
    • Any HDMI/DVI monitor or TV should work as a display for the Pi . For best results, use one with a HDMI input, but other connections are available for older devices. Use a standard Ethernet cable for internet access. The Pi 3 includes built-in wireless LAN.
  • Keyboard and mouse
    • Any standard USB keyboard and mouse will work with your Raspberry Pi.
  • Power supply
    • Use a 5V micro USB power supply to power your Raspberry Pi. Be careful that whatever power supply you use outputs at least 5V; insufficient power will cause your Pi to behave in strange ways.

Not essential but helpful to have

  • Internet connection
    • To update or download software, we recommend that you connect your Raspberry Pi to the internet, either via an Ethernet cable or a WiFi adapter.
  • Headphones
    • Headphones or earphones with a 3.5mm jack will work with your Raspberry Pi.

Plugging in your Raspberry Pi

Before you plug anything into your Raspberry Pi, make sure that you have all the equipment listed above to hand. Then follow these instructions:

  1. Begin by slotting your SD card into the SD card slot on the Raspberry Pi, which will only fit one way.
  2. Next, plug your USB keyboard and mouse into the USB slots on the Raspberry Pi.
  3. Make sure that your monitor or TV is turned on, and that you have selected the right input (e.g. HDMI 1, DVI, etc.).
  4. Then connect your HDMI cable from your Raspberry Pi to your monitor or TV.
  5. If you intend to connect your Raspberry Pi to the internet, plug an Ethernet cable into the Ethernet port next to the USB ports, otherwise skip this step.
  6. When you are happy that you have plugged in all the required cables and SD card, plug in the micro USB power supply. This action will turn on and boot your Raspberry Pi.
  7. If this is the first time your Raspberry Pi and NOOBS SD card have been used, then you will have to select an operating system and configure it. Follow the NOOBS guide to do this.

Read more in our documentation.