Compute Module 3+ 32GB eMMC boot issues

[msg1]

Hi All
I have been using a Compute module 3+ with an offboard ssd card for sometime now .

I need to start using the on board flash version and so have written an image to the board using rpiboot and ImageWriter.

At boot up I get the colourful splash screen but then all I get is this:-

[1] Default EFI Boot Application
[2] Shell
[3] Boot Manager
Start:-

Has anyone seen this before and do you know how to set it up so that it boots straight into IOT10 as per the off board version.

I have looked at the config.txt file , but cant see any obvious changes to be made.

Your help is appreciated

Thankyou

Regards

Mark

[DougieLawson]

You'll need to go and ask Microsoft to provide support for your hardware.

They still haven't added support for 3B+, 3A+ and 4Bs so don't hold your breath waiting.

https://social.msdn.microsoft.com/forum ... WindowsIoT

[msg1]

Hi Dougie
Thankyou for your reply.
I have tried a new module with Raspian and it works fine.
So its a Microsoft issue as you suggested

Regards

Mark