Is there an official spec for the screw to be used if you want to screw the PI4 to the official PI4 case bottom part?
I just received my RPI4 4Gb ram & official case.
I have to admit that I failed to look into the details of the new RPI foundation case for the PI4 before buying it.
I was expecting a part of the lid to come off just like it is for the RPI3 official case, preventing the board from falling from the case.
Well, It is not the case (no pun intended).
I am now planning to use the case without the cover, but I would like to screw the PI4 to the bottom of the case (the red part), to keep the board in place.