New RPi Relay, Opto, XBee, Serial board


2 posts
by BlueBill » Wed Nov 14, 2012 4:10 pm
I'm working on a new Raspberry Pi, Arduino (ATmega328) & PIC (18F26J11) extender board.
4 Relays 5A
4 Opto inputs 3-30V
XBee socket (XBee, WiFi Bee, GPS Bee & Bluetooth Bee compatible)
SC16IS750 (I2C, UART & 8bit I/O port)
MAX3160 (RS232,422,485)
Supports either Raspberry Pi, AVR or PIC (28pin DIP sockets)
1 Wire header (3 pin)
Expandable via 2x5 connector I2C + power
5V required (relays), 3.3V logic.
attachment is an approximation only, designed to show RPi connects (upside down) on PCB.
Comments
ARPIO.jpg
ARPIO.jpg (51.56 KiB) Viewed 761 times
Bill
Posts: 18
Joined: Tue Jul 24, 2012 4:56 am
by mumairanwar92 » Fri Jan 02, 2015 1:09 pm
Hey, did you succeeded in connecting the SC16IC750 with the raspberry pi ?
I am trying to interface it to the raspberry pi through I2C but couldn't understand how to do it as I am beginner of the raspberry pi.
This will be grateful if you help me here...!
Posts: 1
Joined: Wed Nov 26, 2014 6:37 am