Question has been probably asked before but just want to check for my sake.
Currently replacing the USB Micro AB receptacle connector on my carrier board (Houses my CM3) for a USB Type C connector, do I need to change anything for USB_OTG to work on the new connector?
I know that on USB micro I had to get myself a AB connector instead of a A or B connector. So should I be looking for a USB Type C connector that has AB connector or does it just come built in and so I should just add any random Type C connector?
Also according to datasheets I can't seem to find an ID pin on the Type C connector, I noticed online that apparently CC1 & CC2 take on the form of the ID pin however it shows that they need to be pulled up with a 5K Resistor.
My only confusion with this is I want to use both Host and Slave modes. So how would I get around this? Cause I obviously don't want to plug into wall socket and it starts trying to activate OTG mode when I clearly want it to be charging and vice versa plugging into a computer and it not activating OTG mode.