marcas1997
Posts: 1
Joined: Thu Jun 14, 2018 1:04 pm

configuration ipv6 with my rasp

Thu Jun 14, 2018 1:09 pm

Hi all, I am new in this forum, I am glad to be writing and to share my thoughts with you. I am working with a raspberry pi3 and a Web server installed on it. This web-server works on a local network with an IPv4 or IPv6 address. My goal is to reach the IPv6 address of the webserver outside of my network. Is it possible to do this? I attached the my config
Attachments
Cattura.PNG
Cattura.PNG (12.78 KiB) Viewed 253 times

mfa298
Posts: 1155
Joined: Tue Apr 22, 2014 11:18 am

Re: configuration ipv6 with my rasp

Fri Jun 15, 2018 9:00 am

marcas1997 wrote:
Thu Jun 14, 2018 1:09 pm
Hi all, I am new in this forum, I am glad to be writing and to share my thoughts with you. I am working with a raspberry pi3 and a Web server installed on it. This web-server works on a local network with an IPv4 or IPv6 address. My goal is to reach the IPv6 address of the webserver outside of my network. Is it possible to do this? I attached the my config
It is possible to use IPv6 on the Pi (mine are all on IPv6 with no extra config needed).

However the IPv6 address in that screenshot is a link local address so is only accessible on that network segment the key. Other than just knowing that an address starting fe80 is link local the scopeid 0x20<link> tells you. For global IPv6 you need the Pi to also show at least one scopeid 0x0<global> address. If your network is setup for IPv6 then that should happen automatically. The fact you're not seeing a global address would suggest you don't have IPv6 enabled on the network.

Return to “Networking and servers”

Who is online

Users browsing this forum: Baidu [Spider] and 8 guests