Hi, I have a project in the works that incorporates the CM3, so far it has been a great choice.
I was wondering what the best practice is regarding the placement of components on a custom carrier PCB "underneath" the CM3? I see for example on the official CMIO board there are a few resistors there, but would it be okay to place an IC under there, such as a LAN9512?
I believe about 2.8mm of space is available under a CM3, and a LAN9512 is 1mm in height. Would this then be fine, or could you see potential interference issues with placing a sensitive IC such as this so close to the CM3?