Raspberry pi zero W

[BUBLOSq2]

Hello,
i want to do the raspberry zero dongel computer project its very populer in the last time. I have the ver. 1.1(Rasp.W) of the zero and i have no laters on the other side of the pi (the 1.3v have the letters). My question is, cann i do the same on the 1.1v just soldering it to the same points as on the videos? or is the Raspberry Zero W not compatible?
Thanks!

[B.Goode]

Hello,
i want to do the raspberry zero dongel computer project its very populer in the last time. I have the ver. 1.1(Rasp.W) of the zero and i have no laters on the other side of the pi (the 1.3v have the letters). My question is, cann i do the same on the 1.1v just soldering it to the same points as on the videos? or is the Raspberry Zero W not compatible?
Thanks!

It is very likely that most users of this forums will not know what " the raspberry zero dongel computer project" is.

the same points as on the videos?

Could you be specific about which videos you are referring to?

[BUBLOSq2]

The video: "https://www.youtube.com/embed/qbWYUFgLhSU? at:1:42 you can see that the back of the Raspberry pi Zero 1.3v have all this signs on the back and my 1.1v doesent have, so my question is, will it work if i just solder it in the same point as he did.
Dongle projcet, sory for my mistake!

[jamesh]

Not sure why you created a second username to ask anther question - you can just ask questions!

Note, we do moderate first posts, so first posts will not appear straight away, they have to be checked first.

[BUBLOSq2]

Yes sory, this is my second account. I hoppe this is not a big problem.

[alphanumeric]

https://www.raspberrypi.org/magpi/stick-pc-pi-zero/ The only issue is getting the right test points. They have moved around some depending on what version of the Zero You have. shouldn't be to hard to figure out what's what though.
According to this, the test points are in the same positions for the V 1.1 and 1.3 https://zerostem.io/
This backs that up, https://shop.pimoroni.com/products/zero ... connector

[BUBLOSq2]

https://www.raspberrypi.org/magpi/stick-pc-pi-zero/ The only issue is getting the right test points. They have moved around some depending on what version of the Zero You have. shouldn't be to hard to figure out what's what though.
According to this, the test points are in the same positions for the V 1.1 and 1.3 https://zerostem.io/
This backs that up, https://shop.pimoroni.com/products/zero ... connector

Thank you so much, i have alot to learn about raspberry

[alphanumeric]

No problem, have fun. =)