Lanscape lighting

[jlcaudle]

I am wanting to build a project that will turn on a series of landscape lights using a relay board and 2 PIR sensors. One PIR on each end of my run of lights. Ideally when the PIR sensor detects motion it will sequence the lights to come on from the opposite end of the motion with just a slight delay between lighting. I saw something similar to this project a few months ago but now I can't find it. After the lights come on I want them to stay lit for 15 minutes then off.

Can this be done? Im new to this so Im not sure if its even possible for this to work as I have planned it. Anyone know of a similar project?

[DirkS]

Please do not post duplicates.
You already have a response in your other thread: viewtopic.php?f=91&t=182568

[texy]

As DirkS pointed out - you have another thread on this subjext, with a reply which you haven't responded too - please use the original thread.
Thanks
Texy