I was working on getting a USB Flash drive to automount, and I edited fstab, and then rebooted.
I don't know if that was the cause, but now I can't log in.
SSH via WiFi says "Connection refused."
On the serial console, I can see the CM booting, but when it gets to the line:
IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
It just hangs - I get no login prompt. The CM isn't dead - I can connect and disconnect USB devices and see messages reported in the console, but I never get the chance to login.
Since the only way to get out of this is to yank the power, I'm concerned that the Flash has become corrupted.
I am running Minibian, if that is important.
Any suggestions on how to fix this?
Re: CM Stuck - no login prompt
Boot it up via USB in the same way you did to install the software in the first place. Use a Linux system for this (even a Pi will do). Then you will be able to fsck and mount the filesystems on the Linux box and check for corruption/fix the problem.