raspicam motion error

[skatedan]

h guys
when i try to shot a Pic my pi cam return this error message

raspistill -o image.jpg

Code: Select all

mmal: mmal_vc_component_enable: failed to enable component: ENOSPC
mmal: camera component couldn't be enabled
mmal: main: Failed to create camera component
mmal: Failed to run camera app. Please check for firmware updates

how i can solve this problem? And why return this error?

The camera is alredy enabled.
I tried to instal another OS on another SD card but nothing, return equeals issue, should be a cable of raspicam?

[DougieLawson]

What comes out from a vcgencmd get_camera command?

If all is well with the software / hardware then you should get

Code: Select all

pi@odyssey:~$ vcgencmd get_camera
supported=1 detected=1
pi@odyssey:~$

Have you checked wiring including the little SUNNY connector on the camera board? Does the board LED come on?

[skatedan]

So, thanks for the reply,
raspberry return me

Code: Select all

supported=1 detected=1

then all work fine, Now i saw that before don t worked because in background worked motion, But I try to Kill motion And shoot Pic, Red led turn on And turn off But i don' t find a Photo

[DougieLawson]

Try using raspistill

cd /tmp
raspistill -o photo.jpg
ls -la photo*

[skatedan]

I have tried, return me this error

Code: Select all

mmal: No data received from sensor. Check all connections, including the Sunny one on the camera board

[DougieLawson]

Check the ribbon cable (both ends), check the SUNNY connector on the camera board.

[skatedan]

all ends of ribbon Cable are connected also the SUNNY connector

[DougieLawson]

all ends of ribbon Cable are connected also the SUNNY connector

Then your camera board may be dead. Try it on another RPi.

[skatedan]

Ou But red led turn on off

[DougieLawson]

Ou But red led turn on off

That shows your ribbon cable is probably OK. If it's not the SUNNY connector on the front of the camera that's not fully connected then your camera is dead. Try the thumb & forefinger job where you press (quite hard) on the SUNNY connector until you get a faint but audible click.