The VHS-C cassette case is just a little bit larger then the RasPi board, so it fits perfectly. I only had to make some cut-outs for the plugs.
Half an hour later my case was complete. For better hold, I put a piece of antistatic mat under the board.
But now see the pictures of my simple VHS-C case
A simple 0-€-case for Raspberry-Pi...
... it's transparent, so you can still marvel at your RasPi board
A match for better air condition
Some other pics of my new self-made case:
RasPi in action:
Looking forward for comments
