Thanks for your reply. I'm definitely interested in getting some boards, I just need to figure out how many circuits I have room for but I'll IM you when I'm ready.
In the meantime, I had a few questions I was hoping you could answer. I figured I'd post them here as others might benefit as well.
1) The CT you're using (SCT-013) is pretty big and I wouldn't have room to put them on all circuits. Since most of my circuits are 15A or 20A, I was thinking of trying these little 20A solid core CTs:
http://www.aliexpress.com/store/product ... 91810.html
Based on the current input and output specs it appears to have the same 2000:1 turns ratio as the SCT-013. Do you think these can be used as an alternate CT?
2) There are some similar solid core CTs rated for 30A and 50A on ebay, but they have a 1000:1 turns ratio. (For example, 50A/50mA.) Could your software accommodate this? Would the 5 ohm shunt resistors on the CTs need to be changed?
3) (I'm sorry if this is a stupid question...) I followed your instructions on GitHub and the installation seemed to go fine. However, I can't figure out where to point my web browser to interface with it.
Thanks for your help.