ThomasDr
Posts: 55
Joined: Tue May 20, 2014 2:16 pm

Segmentation fault after full upgrade.

Tue Sep 30, 2014 12:46 am

Helllo,


i do a Firmware update with rpi-update and apt-get update and apt-get upgrade.
Now i get an Error if i try to compile.
My compiler command:
g++ -o acc-all acc-all.cpp -lbcm2835

The Error:
collect2: ld terminated with signal 11 [Segmentation fault]

regards
Thomas

fruitoftheloom
Posts: 23093
Joined: Tue Mar 25, 2014 12:40 pm
Location: Delightful Dorset

Re: Segmentation fault after full upgrade.

Tue Sep 30, 2014 8:41 am

ThomasDr wrote:Helllo,


i do a Firmware update with rpi-update and apt-get update and apt-get upgrade.
Now i get an Error if i try to compile.
My compiler command:
g++ -o acc-all acc-all.cpp -lbcm2835

The Error:
collect2: ld terminated with signal 11 [Segmentation fault]

regards
Thomas
Personally because of the the constant changes to Raspbian Wheezy by the RPF always undertake in this sequence:

apt-get update
apt-get dist-upgrade
rpi-update
Rather than negativity think outside the box !
RPi 4B 4GB (SSD Boot)..
Asus ChromeBox 3 Celeron is my other computer...

ThomasDr
Posts: 55
Joined: Tue May 20, 2014 2:16 pm

Re: Segmentation fault after full upgrade.

Tue Sep 30, 2014 11:01 am

Hello,

ok, this resulted in no change.

regards
Thomas

ThomasDr
Posts: 55
Joined: Tue May 20, 2014 2:16 pm

Re: Segmentation fault after full upgrade.

Tue Sep 30, 2014 4:16 pm

Hello,

i switch back to firmware x.26, without success.
last upgrade was bash, the error might be there?

regards
Thomas

UPDATE: The bash upgrade was faulty, I installed bash new, now it works again

Return to “C/C++”