I am trying to interface MPU-6050 with the Raspberry Pi,
Since it require i2c connections so I have connected using the following pins,
3.3V connect to VCC
SDA connect to SDA
SCL connect to SCL
Ground connect to GND
but when I am checking if the device is detected using,
, nothing is displayed beside the empty i2c address table.
Code: Select all
i2cdetect -y 1
On the other hand, the MPU-6050's yellow light is turned on when i have connected it.
I am sure that i have done everything correct because other sensor (BMP085) is being normally displaying in the i2c address table when i am trying to connect it, ADC Pi is also normally showing in the i2c table.
I have tried to connect MPU6050 with and without BMP085, but in either case , its memory address is not displaying in the i2c address table.
What could be the problem here ?
beside, VCC, SDA, SCL and GND, am i supposed to connect any other pins too ?
the other pins are,
XDA, XCL, ADD and INT
Kindly help me with that