Posts: 1
Joined: Thu Aug 22, 2019 9:35 am

Replace a component

Thu Aug 22, 2019 9:43 am

I have an old model of Raspberry Pi 2011.12, it should be a Model B. Unfortunately, one component came off and the terminals broke. I cannot therefore understand how and with what (polarity, type of component and capacity) replace it. Can you help me? I am not an electronics expert and, even with all the difficulties, I would like to start this journey. Thank you. I enclose a photo of the circuit.
In red the component to be replaced.
Rapsberry_pi_2011.12-m.jpg (192.54 KiB) Viewed 476 times

Posts: 1492
Joined: Tue Jun 30, 2015 1:35 pm

Re: Replace a component

Thu Aug 22, 2019 11:58 am

Thats a 220uF capacitor, rated at 16V (if I'm right from my mind)

Package type is D8. Can't give a recommendation where to buy it as I don't know ypour location. ... ageSize=25

Posts: 6591
Joined: Sat Jan 12, 2013 3:01 am
Location: Grants Pass, OR, USA
Contact: Website

Re: Replace a component

Thu Aug 22, 2019 12:29 pm

The black marking goes to the edge of the board (ground) as in your photo.
With a good power supply the board will work OK without that capacitor.
Others have replaced that cap with a radial lead device instead of surface mount.
Unless specified otherwise my response is based on the latest and fully updated Raspbian Buster w/ Desktop OS.

User avatar
Posts: 15200
Joined: Sun May 06, 2012 5:17 am
Location: Chelmsford, Essex, UK

Re: Replace a component

Thu Aug 22, 2019 12:38 pm

That's a PI 1B Rev 2.0. Others have already stated what the capacitor is.

Return to “Interfacing (DSI, CSI, I2C, etc.)”