So I finally opened my new raspberry pi 3 and installed rasbian off the preloaded sd card. I followed some tutorials from this site to flash and LED and I just coulnd't get it to work. After a long troubleshooting session I started checking voltages on the gpio and came to the realization that it is completely different from what it should be. It has only one ground connection that is actually a proper ground, mainly GND 39.
Here are the voltage read outs on some of the pins(Didn't do all):
3.3V = 4.4V 5V= 5V
GPIO2= 3.3V 5V= 5V
GND = 4.4V
Am I missing a driver for it?
Any help would be greatly appreciated.