I decided to user Thermal Paste for my heatsinks on the RP3 and like a dummy put a bit too much, it ran off onto the board. I used some alcohol and q-tips to try to clean it up the best I could but now when I start the Pi I get no picture. The lights still power on and blink like normal but my monitor gets no signal. Everything worked fine before this incident.
I'm assuming the board is dead but figured I'd ask here if anyone has any other ideas.
FYI, Thermal Paste used was some left over Arctic Silver - 5 High-Density Polysynthetic Silver 3.5g I had from building my PC.