svrsig wrote:Does that mean that the EMMC lines CLK CMD D0 D1 D2 D3 are GPIO 48 to 53 so that software that controls an SD card on model B+ using GPIO 48 to 53 should just work 'out of the box' on the Compute module?
Or is there some subtlety required?
I believe it works 'out of the box' on Linux (since the kernel includes both SD and eMMC drivers), but it appears there's some subtle difference between SD and eMMC when it comes to RISC OS? http://www.raspberrypi.org/forums/viewt ... 04#p589404
(oh, didn't realise that was you too!)
I'm afraid I dunno what those 'subtle differences' are myself.