aroman_ro
Posts: 20
Joined: Mon May 06, 2019 2:01 pm

Cannot flash eMMC anymore...

Mon May 06, 2019 2:08 pm

I'm using CM3 the dev board. I tried to make it boot from the network (I already did that with a pi 3) and I think I managed to brick the device.

It was booting from the flash nicely, but after a software update, it refused to boot. Of course, I tried to access the eMMC to flash a new image, but I couldn't anymore. Apparently this "program_usb_boot_mode=1" prevents one to access emmc. Is there a workaround?

I found this: viewtopic.php?t=179284 but I'm not sure it would work with the dev board...

Thanks,
Adrian

Return to “Compute Module”