Bocana
Posts: 1
Joined: Wed May 09, 2018 12:24 pm

Flashing the CM3 with Compute Module IO board

Wed May 09, 2018 12:31 pm

Hello,
I would like to flash my RPI CM3 with a CM IO Board. I am following this tutorial : https://www.raspberrypi.org/documentati ... lashing.md

Whereas, when I'm connecting the Board to my PC, and making doing : sudo ./rpiboot . Nothing appends ... I have just this message : Waiting for BCM2835/6/7

I put the jumper J4 (USB Slave Boot Enable) to ENable, and I am using a Ubuntu on my PC.

Have you got any idea ?

Thanks !

PhilE
Raspberry Pi Engineer & Forum Moderator
Raspberry Pi Engineer & Forum Moderator
Posts: 1907
Joined: Mon Sep 29, 2014 1:07 pm
Location: Cambridge

Re: Flashing the CM3 with Compute Module IO board

Wed May 09, 2018 2:11 pm

1. I assume the CMIO board is powered?
2. What does "lsusb" show on the PC?
3. Do you have a regular Raspberry Pi to use as a known good host for testing?

gsh
Raspberry Pi Engineer & Forum Moderator
Raspberry Pi Engineer & Forum Moderator
Posts: 1347
Joined: Sat Sep 10, 2011 11:43 am

Re: Flashing the CM3 with Compute Module IO board

Wed May 09, 2018 3:00 pm

Are you sure you've got the PC plugged into the USB slave connection and power connected to power in? Do both the red and green LEDs come on and stay on?

Gordon
--
Gordon Hollingworth PhD
Raspberry Pi - Director of Software Engineering

Return to “Compute Module”