No, I'm afraid not, it shows a raspberry pi not a compute io board and the connectors are different.DougieLawson wrote:Does this video help: https://www.raspberrypi.org/help/camera-module-setup/
Thanks. Sorry to be stupid, do you tug forwards, backwards, or up?DougieLawson wrote:The connectors are the same basic design. Tug the clip gently until it moves, slide the cable in, press the clip home.
Uffda!leol wrote:now I have broken one of the connectorsDougieLawson wrote:tug parallel to the small circuit board.
You don't seem to have much finesse, but I think 'stupid' might be too harsh a label to pin on oneself.leol wrote: Thanks, but I must be being very stupid
Never give up; sooner or later, you'll get it right.leol wrote:Still can't do it ... guess I'll give up!
Yes, the connector is that same, and--yes--the cable should work. I just haven't seen anyone say that they have actually done so.Frederir wrote:To the best of my knowledge the Pi Zero camera connector is the same as the CM connector. So a Pi Zero camera flex should work directly on CM.
Waiting for PI zero schematic to be sure.