Page 1 of 1

How to Run Tests in Command Line Wolfram

Posted: Sat Oct 25, 2014 7:13 am
by PeterWAWood
Is it possible to write Wolfram tests using the Wolfram command line. When I tried I got this message and the tests didn't run:

Code: Select all

Wolfram Language (Raspberry Pi Pilot Release)
Copyright 1988-2014 Wolfram Research
Information & help: wolfram.com/raspi

In[1]:= VerificationTest[Sin[E]>Cos[E]]                                         

Get::noopen: Cannot open MUnitLoader`.

Out[1]= VerificationTest[True]

Re: How to Run Tests in Command Line Wolfram

Posted: Sat Oct 25, 2014 3:20 pm
by PeterWAWood
The unit tests also appear to be missing from the Notebooks too. I get the same "Get::noopen: Cannot open MUnitLoader`." message.

Re: How to Run Tests in Command Line Wolfram

Posted: Sun Oct 26, 2014 2:41 am
by PeterWAWood
I asked a similar question on the Wolfram Raspberry Pi forum. The answer was that Munit is not in the current Raspberry Pi release and that it may be in a future one.

I do hope so.

Re: How to Run Tests in Command Line Wolfram

Posted: Sat Feb 07, 2015 3:42 am
by szhorvat
This does appear to work now in the latest, 2015 Jan 29 version.

Re: How to Run Tests in Command Line Wolfram

Posted: Mon May 11, 2015 10:37 am
by PeterWAWood
I've just seen your message. Thanks, it's good to know and will encourage me to make time to learn Wolfram.