Hello, i recently installed debian onto my pi, and i've been following this guide;
to try and get my Belkin wifi adapter working, the exact same as he specifies at the top. I installed the firmware properly and i'm struggling at the last bit. When i restart my pi, as it starts up i see something, /etc/network/interfaces:2: too few parameters for iface line
ifup: couldn't read interfaces line
My interfaces file is as follows starting directly under here:
iface wlan0 inetdhcp
auto lo wlan0
iface wlan0 inet dhcp
This is the end of it, obviouslly passwordhere is replaced with my router password. is this correct? if not, how do i correct it?