Safe 4 push button layout?

[Nathan24816]

I want to have 4 push buttons attach to the raspberry pi. Is the layout below safe to use (current draw, shorts, etc)? I'm using pull down for all of them.

Thank you!

[neilgl]

Image is missing?

[Burngate]

I want to have 4 push buttons attach to the raspberry pi. Is the layout below safe to use (current draw, shorts, etc)? I'm using pull down for all of them.

Thank you!

The image doesn't appear to be liked by the forum software, so here it is again:

M9UynJr.png (25.79 KiB) Viewed 172 times

Yes, it should be fine, but note the connection is for the old 26-pin GPIO header

[Nathan24816]

I want to have 4 push buttons attach to the raspberry pi. Is the layout below safe to use (current draw, shorts, etc)? I'm using pull down for all of them.

Thank you!

The image doesn't appear to be liked by the forum software, so here it is again:
M9UynJr.png
Yes, it should be fine, but note the connection is for the old 26-pin GPIO header

oops, I didn't notice the pins. I just counted from the top. Thank you!