RaspBMC UI Installer fails
Posted: Sun Dec 09, 2012 10:31 pm
I am trying to install RaspBMC to an 8GB SD Card using the UI Installer (for Windows) here:
http://www.raspbmc.com/download/
The Windows installer completes OK and after safely removing the Card from the Windows PC and installing it in the RPi connected with a WIRED Ethernet connection to the Internet, it boots up and starts downloading the HUGE RootFS .... this completes successfully and then goes on to Install the RootFS.
So far so good. It then goes on to download the Kernel Modules and proceeds to install the Kernel Modules which complete 100%.
It then appears to try to run initialise-hardfp.sh and fails lines 143 to 160 .... then hangs and does nothing.
Can anybody here help ... or point me to a more appropriate thread please.
http://www.raspbmc.com/download/
The Windows installer completes OK and after safely removing the Card from the Windows PC and installing it in the RPi connected with a WIRED Ethernet connection to the Internet, it boots up and starts downloading the HUGE RootFS .... this completes successfully and then goes on to Install the RootFS.
So far so good. It then goes on to download the Kernel Modules and proceeds to install the Kernel Modules which complete 100%.
It then appears to try to run initialise-hardfp.sh and fails lines 143 to 160 .... then hangs and does nothing.
Can anybody here help ... or point me to a more appropriate thread please.