And MOST of the pins change, but not all. In my case the pins 13, 23, 24, 28 and 19 are still 'floating' and the pull up resistor is not engaged. I can engage it manually from the command line and the pins respond but not through the config file. I have even tried the commands individually and those pins do not obey the config file. I have watched them during boot and they do not flicker or change then change back so I don't think there is another file conflicting with it.. I have also only modified the one file for this purpose, so any conflicts would be from stock raspbian.
Code: Select all
# Set GPIO Default Positions # Set to Pull Up Output gpio=22,23,24,25,26,27,28,29=pu,dh,op # Set To Pull Up Input gpio=1,4,5,6,10,11,12,13,14,15,16,=pu,ip
Any thoughts or guidance?