Raspberry Pi Forums

Hi,
I'm hoping someone can point me in the right direction as I'm sure I'm missing something simple. I'm trying to set my raspberry pi up as an Eynio server to enable me to use Eynio Click to control switches in my house. I have been trying to understand how to do this for hours and have made little progress.
If anyone can make any suggestion for how I get this to work, it would be greatly appreciated. The link to the downloads I am trying to use is https://eynio.com/wp/downloads/ I have tried using both the Installer and the Raw Image options but have had no success with either.
Thanks.

i noticed that image and install explicitly use the PI2 hardware rev??
is that the hardware you use?

Many thanks, I knew it would be something straight forward; it's 3rd gen I have.

Back to the drawing board with working out how to get my Orvibo S20's linking to my Amazon Echo.

Eynio definitely supports the rpi3. What happens when you boot the image?

I have the same pb with PI Zero W -- no installer works
Will that zero be supported?

lcd wrote: ↑

Mon Oct 16, 2017 8:46 pm

I have the same pb with PI Zero W -- no installer works
Will that zero be supported?

Not with an image for RPi2 / RPi3.
Zero, Zero with camera, Zero W are all using the same chip as the RPi1B, RPiA+ and RPiB+. Currently there are no new models in the plan (apart from the mythical RPi3A).

Go and ask the developers of Eynio to support the other RPi SoC chip.