I have written a program in Python2 on my RPi and it runs happily.
The program takes a keystroke from the connected keyboard and turns on/off/speeds up a DC motor.
When I try to submit a keystroke from my MacBook Air via VNC the program does not accept the keystroke as an input to the program it just prints the keystroke.
I have VNC running and it seems to do everything it should be doing. I can connect to the RPi using SSH from my Mac. All connections seem fine, but I can not remotely "input" a keystroke.
What to do???
Thank you for any help.
It's hot here in Australia, hope it's nice where you are.
4 posts • Page 1 of 1