startpar: service(s) returned failure networking...failed!

2 posts
by CianHa » Fri Mar 01, 2013 8:55 pm
I'm getting the above message during startup, and my eth0 is not getting an IPaddress.

Not sure what I've done to cause this, I recently added a wlan0 card, but it had been working OK.

can't run ifup ifdown nor ifquery, returns "command not found"

Do I need to re-image the card again?
Posts: 17
Joined: Sun Jul 29, 2012 9:10 pm
by -rst- » Tue Mar 05, 2013 4:03 pm
Maybe try 'sudo ifup'? - Low-level graphics and 'Coding Gold Dust'
Posts: 1315
Joined: Thu Nov 01, 2012 12:12 pm
Location: Dublin, Ireland