Page 1 of 1

Gibberish output from GPS module

Posted: Sat Jun 29, 2019 5:03 am
by dipayan
Hello

Some background first. With some help from community members, I managed connect a GPS module(Link mentioned below with info about the model) with my raspberry pi 3b+ through USB port. I can see a device ttyUSB0. I have installed minicom package and tried "minicom -b 4800 -o -D /dev/ttyUSB0' command. It keeps on giving me a gibberish output. My language setup is en.UTF8. Also I waited for 20 mins to get a lock-in. I also disabled bluetooth by changing config.txt.

Anything else that I can do to get a genuine output from the GPS module ??

GPS module info link : https://wiki.52pi.com/index.php/USB-Por ... KU:EZ-0048

Regards, D

Re: Gibberish output from GPS module

Posted: Sat Jun 29, 2019 8:05 am
by Bakul Shah
The link you posted says the default baud rate is 9600 while you are specifying 4800. This can be an issue.

Re: Gibberish output from GPS module

Posted: Sat Jun 29, 2019 10:03 am
by jamesh
Closing as a duplicate. See other thread.