abrams
Posts: 13
Joined: Mon Oct 16, 2017 3:26 pm

sdhci_send_command error

Sun Mar 24, 2019 12:53 pm

Hi,
On my SD card I have installed U-boot.
Through that I give via bootm command a memory address to boot my program but after the load process
I receive non-stop messages that saying the following error:

Code: Select all

"sdhci_send_command: Controller never released inhibit bit(s)"
This is happening with both my RPI2,3 and by using different SD cards.
I was wondering If anyone knows why I receive that error message? Is because of hardware SD slot? or because of my software?
Is there any way to disable the message and not receive sdhci messages?

Thanks!

Return to “General discussion”