skypi
Posts: 111
Joined: Sat Aug 09, 2014 11:48 pm

can you boot raspbian with pins default output on?

Sat Sep 29, 2018 3:29 am

can you boot raspbian with pins default output on?

seems to default pins are input, which with rgb leds hooked up to sink to pins does have a nice low level all leds on type effect, but want them to perhaps start like that but then instantaneous all off... or individually from low-light effect to each off...

but not, low light off, full on, full off, as using sys/gpio does...

maybe it is that they default to "floating" which would be nice to be able to set through sys/gpio like 1 level of pwm so could have

a) off (1 or 0)
b) floating low light pwm (some hazy state which seems more like near 1 than 0 in my sink to pin set up)
c) full on (0 or 1)

User avatar
DougieLawson
Posts: 38768
Joined: Sun Jun 16, 2013 11:19 pm
Location: A small cave in deepest darkest Basingstoke, UK
Contact: Website Twitter

Re: can you boot raspbian with pins default output on?

Sat Sep 29, 2018 5:56 am

Note: Any requirement to use a crystal ball or mind reading will result in me ignoring your question.

Criticising any questions is banned on this forum.

Any DMs sent on Twitter will be answered next month.
All non-medical doctors are on my foes list.


Return to “General discussion”