Page 1 of 1

Raspberry Pi Zero Eagle Footprint / LBR

Posted: Sat Nov 28, 2015 10:52 am
by peter6960
I created an Eagle footprint for the Zero:

Hope you find it useful

Re: Raspberry Pi Zero Eagle Footprint / LBR

Posted: Mon Nov 30, 2015 1:50 pm
by TonyD
Thanks for sharing.

Re: Raspberry Pi Zero Eagle Footprint / LBR

Posted: Sun Mar 26, 2017 4:27 am
by inches
I'm opening these up in Eagle 8.1.0 and notice that when I place the schematic in my schematic the board doesn't show up on my board linked to it. Is this a version issue for Eagle 8.1.0, am I using the lib wrong, or were they ever hooked up like that?

Re: Raspberry Pi Zero Eagle Footprint / LBR

Posted: Sun Apr 02, 2017 11:45 pm
by George Twiceight
Used today in Eagle 8.1.0 and it shows up perfectly. I don't know the cause of your issue. Which kind of license do you have?

Re: Raspberry Pi Zero Eagle Footprint / LBR

Posted: Fri Jan 12, 2018 9:42 pm
by pierrot10
Dear Peter

Thank for that PCB.
I am doing an hat for a Raspberry Zero W. I never know the min width of a route
For know I select 0.3

Second stupid question: from where can I define the unity. I supposed 0.3 are not millimter?

Many than ofr your help

Re: Raspberry Pi Zero Eagle Footprint / LBR

Posted: Sun Mar 24, 2019 1:10 pm
by aarkay14
Can I reqeust the OP to provide the SMT footprint as well. I can see that this one has THT footprint only!

-Rama

Re: Raspberry Pi Zero Eagle Footprint / LBR

Posted: Mon Mar 25, 2019 2:44 am
by DirkS
aarkay14 wrote:
Sun Mar 24, 2019 1:10 pm
Can I reqeust the OP to provide the SMT footprint as well. I can see that this one has THT footprint only!
Of course you can, but OP has not logged in to the forum for more than 3 years...