Page 1 of 1

Font Size

Posted: Wed May 13, 2015 4:35 am
by 1775
I can change fonts and I can make them bold, etc. But I can't find a way to make them bigger. I am straining my eyes trying to read the screen. Monitor only works as Auto and resolution is greyed out. Any attempt to cange to another monitor results in huge text on a small part of the screen and then I can't get out of that without pulling the plug. I tried Generic and that did not work - same result as I described in the last sentence. (Rasp2 B)

Any help appreciated.

Re: Font Size

Posted: Wed May 13, 2015 9:40 am
by apacketofsweets
Just had a quick play around and I can't for the life of me figure out a way to do it through the GUI. I swear previous versions of RISC OS allowed this, although I've just booted up 4.02 and I still can't find a way to change the system font size.

!MiscSetup by the late Paul Vigay should do the trick though - http://www.vigay.com/software/miscsetup.html

Re: Font Size

Posted: Wed May 13, 2015 9:30 pm
by 1775
apacketofsweets wrote:Just had a quick play around and I can't for the life of me figure out a way to do it through the GUI. I swear previous versions of RISC OS allowed this, although I've just booted up 4.02 and I still can't find a way to change the system font size.

!MiscSetup by the late Paul Vigay should do the trick though - http://www.vigay.com/software/miscsetup.html
!MiscSetup worked! The pinboard is readable now. Now, if I can only change the micro font size in StrongED...

Thanks!!!!