I'm having trouble configuring and pairing it. In particular, it seems that none of the config I put in main.conf are ignored: device name, class, discoverability...
Here is hciconfig -a hci0:
Code: Select all
[[email protected] ~]$ hciconfig -a hci0 hci0: Type: BR/EDR Bus: USB BD Address: 00:15:83:0C:BF:EB ACL MTU: 339:8 SCO MTU: 128:2 UP RUNNING PSCAN ISCAN RX bytes:1217 acl:0 sco:0 events:42 errors:0 TX bytes:672 acl:0 sco:0 commands:42 errors:0 Features: 0xff 0x3e 0x85 0x30 0x18 0x18 0x00 0x00 Packet type: DM1 DM3 DM5 DH1 DH3 DH5 HV1 HV2 HV3 Link policy: RSWITCH HOLD SNIFF Link mode: SLAVE ACCEPT Name: 'alarmpi' Class: 0x000104 Service Classes: Unspecified Device Class: Computer, Desktop workstation HCI Version: 2.0 (0x3) Revision: 0xc5c LMP Version: 2.0 (0x3) Subversion: 0xc5c Manufacturer: Cambridge Silicon Radio (10)
Code: Select all
[General] # Default adaper name # %h - substituted for hostname # %d - substituted for adapter id # Defaults to 'BlueZ' Name = Jukebox # Default device class. Only the major and minor device class bits are # considered. Defaults to '0x000000'. Class = 0x200420 # How long to stay in discoverable mode before going back to non-discoverable # The value is in seconds. Default is 180, i.e. 3 minutes. # 0 = disable timer, i.e. stay discoverable forever DiscoverableTimeout = 0 # How long to stay in pairable mode before going back to non-discoverable # The value is in seconds. Default is 0. # 0 = disable timer, i.e. stay pairable forever PairableTimeout = 0 # Automatic connection for bonded devices driven by platform/user events. # If a platform plugin uses this mechanism, automatic connections will be # enabled during the interval defined below. Initially, this feature # intends to be used to establish connections to ATT channels. Default is 60. #AutoConnectTimeout = 60 # Use vendor id source (assigner), vendor, product and version information for # DID profile support. The values are separated by ":" and assigner, VID, PID # and version. # Possible vendor id source values: bluetooth, usb (defaults to usb) #DeviceID = bluetooth:1234:5678:abcd # Do reverse service discovery for previously unknown devices that connect to # us. This option is really only needed for qualification since the BITE tester # doesn't like us doing reverse SDP for some test cases (though there could in # theory be other useful purposes for this too). Defaults to 'true'. #ReverseServiceDiscovery = true # Enable name resolving after inquiry. Set it to 'false' if you don't need # remote devices name and want shorter discovery cycle. Defaults to 'true'. #NameResolving = true # Enable runtime persistency of debug link keys. Default is false which # makes debug link keys valid only for the duration of the connection # that they were created for. #DebugKeys = false #[Policy] # # The ReconnectUUIDs defines the set of remote services that should try # to be reconnected to in case of a link loss (link supervision # timeout). The policy plugin should contain a sane set of values by # default, but this list can be overridden here. By setting the list to # empty the reconnection feature gets disabled. #ReconnectUUIDs=