Posts: 1
Joined: Sun Jul 22, 2018 2:46 pm

RaspberryPI GPIOs don't work

Sun Jul 22, 2018 2:51 pm

I have RaspberryPI with Arch Linux and everything was going well, until this morning when I tried to do my usual work on it, it sounds like nothing happening at all, I have checked with pintest (I use wiringPi with C) it gives me every thing is ok, also with

Code: Select all

gpio readall
gives me the right mode of each pin but there is no output voltage at all and also the input doesn't work.
I don't know what information should I have too, your help will be appreciated

Return to “Arch”