I recently ordered this board from texy (thanks again!)
For my project, I managed to squeeze it into the case I was hoping it would fit into. Yay! Pictures:
http://i904.photobucket.com/albums/ac24 ... f7da22.jpg
http://i904.photobucket.com/albums/ac24 ... cf5f74.jpg
Now I need to connect it up to the pi and get it displaying. I probably should have done that first, but I was impatient to see if it would fit!
You can see from the pictures that I needed to cut off the bottom row of the header pins that, making that un-usable. From my inspection of the wire traces, it looks like all of the display pins connect directly to the center connecter, so I think my cut will not break any traces going to the display.
I plan on just connecting a cable from the pi to the connecter on the center of the display board. If I need to access the additional GPIO pins I will need to use a splitter cable or something.
Anyway, I will update again with my experiences getting the display working.