I was going to use two of the FT232RL to give me the other two serial ports with a VCP.
It seams to recognize the device. I am using Soft-float Debian “wheezy” (just downloaded yesterday) from what I have read on the form better supports the device. I have installed the D2xx drivers using these sources:
http://www.ftdichip.com/Support/Documen ... rry_Pi.pdf
http://www.ftdichip.com/Support/Documen ... nux%20.pdf
When using the examples or trying to access the ports directly it seams that they don't want to work. (or it hangs) I read the other two form posts about this problem but I couldn't figure out how they fixed the issue.
Thanks for any help!
Code: Select all
[ 1372.844298] ftdi_sio 1-1.3:1.0: device disconnected [ 1382.043810] usb 1-1.3: new full-speed USB device number 5 using dwc_otg [ 1382.151666] usb 1-1.3: New USB device found, idVendor=0403, idProduct=6001 [ 1382.151696] usb 1-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [ 1382.151713] usb 1-1.3: Product: FT232R USB UART [ 1382.151725] usb 1-1.3: Manufacturer: FTDI [ 1382.151736] usb 1-1.3: SerialNumber: A100S676 [ 1382.168288] ftdi_sio 1-1.3:1.0: FTDI USB Serial Device converter detected [ 1382.168461] usb 1-1.3: Detected FT232RL [ 1382.168479] usb 1-1.3: Number of endpoints 2 [ 1382.168493] usb 1-1.3: Endpoint 1 MaxPacketSize 64 [ 1382.168507] usb 1-1.3: Endpoint 2 MaxPacketSize 64 [ 1382.168520] usb 1-1.3: Setting MaxPacketSize 64 [ 1382.169270] usb 1-1.3: FTDI USB Serial Device converter now attached to ttyUSB0
P.S. - I used this command - minicom -b 9600 -o -D /dev/ttyUSB0
Code: Select all
Module Size Used by snd_bcm2835 19889 0 snd_pcm 74834 1 snd_bcm2835 snd_seq 52536 0 snd_timer 19698 2 snd_seq,snd_pcm snd_seq_device 6300 1 snd_seq snd 52489 5 snd_seq_device,snd_timer,snd_seq,snd_pcm,snd_bcm2835 snd_page_alloc 4951 1 snd_pcm