I have followed the "Gordons guide" for the Arduino IDE and all works well except the serial Minicom?
Or perhaps it is not working as I expected?
I often get , for example with "Analog In, Out Serial"
A seemingly corrupt output/display with cpu at approx 25% ( bargraph)
Or I get a stream of correct? data, usually after a Ctrl-A X and then a restart of Minicom
sensor = 173 output = 43
as a very fast stream that sends the cpu to flat out.
So any ideas of what is causing the glitch/corruption and how to sort it?
Is there a way to slow up the data stream when it does work in Minicom to drop the cpu load?
I have tried a purge and re install of Minicom.
(Raspian Oct 28 , Updated)