Page 1 of 1

Sense Hat

Posted: Sat Jul 29, 2017 6:12 pm
by oscarcuenca2
Hi.
I connected sense hat to my pi when it was turned on. I know, A big mistake. I would like to know how to know if my sense hat shield is "caput". I am traying to connect it with Node-red. But show all the time as "disconnected" and not leds are shinning after running a *.py basic for leds.. Any idea how to test if it is working and if not there is any possibility to take it back to alive.

Thanks for any help-

Re: Sense Hat

Posted: Wed Aug 16, 2017 7:53 pm
by alphanumeric
You should probably post this in the Astro Pi section, viewforum.php?f=104 as suggested in the sticky. Or as a moderator to move it.
I'd look to see if its detected by I2C.