Should be fine. Have a look at this if you want conformation - you just need to look at the first paragraph or 2 though:HB wrote:As part of a project for fitting a RasPi into a NES case, I want to have the NES's power LED functional for showing if the Pi is being powered. Based on the LED output tutorial on the wiki, I believe hooking the LED along with a 270 Ohm resistor up to the 3.3V pin on the GPIO should work and not burn anything out. Is this correct, or is there something else I need to take into account?
Users browsing this forum: No registered users and 11 guests