I am wanting to use the Xbee Wireless Serial board (RS485) and a Pi to connect with my LEGO NXT robots using NXTbee interfaces http://www.active-robots.com/nxtbee.html.
For my paid-for-but-not-arrived-pi I have purchased an XBee 5V/3.3V Adapter Board http://www.active-robots.com/xbee-5v-3- ... board.html This should connect to the UART port on the Pi, however is has been a while since I last made up a lead for this kind of this thing. Can anyone say if if I were to make a cable with these connections are correct?:
Code: Select all
Pi Header Xbee interface P1-01 3v3 VCC 3v3 P1-06 Gnd Gnd P1-08 UART0_TXD DIN P1-09 UART0_RXD DOUT