Kampi
Posts: 66
Joined: Sun Oct 07, 2012 12:05 am
Location: Monheim, Germany
Contact: Website

Question about 1Wire

Sun Mar 17, 2013 12:12 pm

Hello Guys,

i´m using 1Wire for my Raspberry Pi:

http://webshed.org/wiki/RaspberryPI_DS1820

Now i have a Question. Can i use the 1Wire for other Devices than an DS1820 Temperaturesensor on the same Way or is this way only for a DS1820.
I want to connect some other 1Wire Devices on my rPi but i don´t know if they got listed in the /sys/bus/w1/devices Folder.
Can somebody help me please :)

Thank you.
Greetings
Daniel
Meine Homepage:

www.Kampis-Elektroecke.de

beakersoft
Posts: 28
Joined: Thu Apr 26, 2012 4:35 pm

Re: Question about 1Wire

Mon Mar 18, 2013 2:38 pm

You can use lots of devices on 1-wire, the DS1820 sensor is probably the easiest though, as the sensor itself ‘talks’ the 1-wire protocol.
There is a DS2438 device, that while designed to be used a battery monitor will allow you to interface into different sensors. Your best bet is probably to look at using that. Oddly enough I’m in the middle of creating a pcb add on board for the pi to provide 1-wire support over RJ45.

repton
Posts: 91
Joined: Sat Mar 17, 2012 6:06 pm
Location: North Yorkshire, UK.
Contact: Website

Re: Question about 1Wire

Mon Mar 18, 2013 8:36 pm

beakersoft wrote:Oddly enough I’m in the middle of creating a pcb add on board for the pi to provide 1-wire support over RJ45.
Like this:
http://www.sheepwalkelectronics.co.uk/RPI1.shtml
or this:
http://www.sheepwalkelectronics.co.uk/RPI2.shtml

The first one connects to GPIO4 to use the kernel 1-Wire driver, the second is an I2C based master.

Regards,
Paul
UK Supplier of 1-Wire components, kits and modules:
http://www.sheepwalkelectronics.co.uk/

Return to “Interfacing (DSI, CSI, I2C, etc.)”