I am setting up a test project where I am using a digital potentiometer to change the intensity of a LED light. I am new to electronics for the most part so was looking for a little direction. I have spent a fair amount of time reading the datasheet for my chip and searching the message board and think I have the wiring right but wanted to see if any one could confirm if this is correct (my apologies for the crude diagram but it was the best I could do).
Full size image: http://www.kymark.com/spiled.jpg
Here is the link to the datasheet for the digital pot chip I am using (it is the 8 pin one).
http://ww1.microchip.com/downloads/en/d ... 11195c.pdf