I'm a Raspberry Pi newbie but I'm very excited to learn.
For a project I'm working on, I need to be able to communicate using CAN and RS485 at the same time.
I have been looking at how I can enable CAN functionality on the RP3 and I have found the PiCAN2. I have also been eyeing the Sparkfun BOB-10124 breakout board for RS485.
I was having a look at the pictures and it seems like the PiCAN2 takes up all 40 pins on the RP3. So if I need to wire the RS485 to the RP3, how would I do it at the same time? Is it even possible? If not, should I look for a USB-RS485 adaptor?