Posts: 5
Joined: Fri Mar 17, 2017 8:49 am

Re: [quick-guide] CAN bus on raspberry pi with MCP2515

Tue Dec 31, 2019 12:00 am

Chaeben wrote:
Tue Jul 19, 2016 6:52 pm
Currently I am Programming a driver for the MCP2515 on Windows 10 Iot and managed to establish a connection.
@Chaeben did you manage to get the pi using WinIot to work?
Im trying a project now and still new to Can so after any help from any one to get it working in Windows versions of Pi3 please

Posts: 4
Joined: Thu Jun 13, 2019 9:05 pm

Re: [quick-guide] CAN bus on raspberry pi with MCP2515

Sat Jan 11, 2020 11:09 pm

I took a slightly different aproach after see that SN65HVD230 is both 3.3v and pin compatible with the TJA1050 that was on my board, I just replaced, running the whole module off 3.3v.

Posts: 6
Joined: Wed Oct 23, 2019 1:39 pm

Re: [quick-guide] CAN bus on raspberry pi with MCP2515

Sat Feb 01, 2020 3:04 pm

i'm trying to follow the instructions from the first page.
But: when i connect the 5V (Pin 2 GPIO) to the TJA1050 Transreceiver Pin 3, my Raspberry PI 4 won't boot. Just the red power LED from raspi is on, and the green LED is not blinking. as soon as i disconnect the 5V, the raspi boots up.

if i'm connecting the 5V when the raspi is alredy up and running, it stops responding.
any ideas ?
i checked if i have a short betveen 5V and GND, and no .. no short.
anyone got this to work with a raspberry pi 4 ?


Posts: 2
Joined: Fri Feb 14, 2020 2:49 pm

Re: [quick-guide] CAN bus on raspberry pi with MCP2515

Tue Feb 18, 2020 2:00 pm

Hi there. I understand that you are using a CAN converter power supply to contact the capacitor and connect it to + 5V.
Tell me how to attach this to the arduino?Advice is needed... :D

Return to “Interfacing (DSI, CSI, I2C, etc.)”