I am connected to RPi 3B via my PC terminal - ssh [email protected]
I can identify the "pi" controller as such , no problem.
When I do "devices" I get three.
One of them should be the built-in adapter.
(Right ? I need controller and an adapter ?)
I have verified that by using other command as using UART which is OK.
I like to find out how is the "jim_desktop" listed as bluetooth device.
Since I am using PC as ssh terminal I just cannot disconnect it to find out it will no longer be listed as "bluetooth device".
I have no clue what is the third device I am picking up, but that is not important at this point.
I am sure there are other commands I can use to further identify the devices (info ) , by just using their known address.
No problem there.
Controller B8:27:EB:11:3F:82 pi [default]
Device 00:50:B6:80:4D:5D jim-desktop bluetooth device (?)= "points to " terminal application running on my PC ?
Device 68:64:4B:16:CD:9E 68-64-4B-16-CD-9E
Device 65:78:C6:60:64:33 65-78-C6-60-64-33