Why is my Rasberry Pi Camera board stream so slow?

[icecats]

Dear Pi community,
I have been using an Rpi camera board with the 3D print server Octoprint so that I can watch my prints remotely. However, when I visit octopi.local to control and monitor my 3D print, the camera module footage is extremely slow and choppy. I think that this may have something to do with my home network speed. Please refer to https://groups.google.com/forum/#!topic ... iv3EYQ1ez0forum post for videos and more information on my problem. Thanks, icecats

[kusti8]

I use mjpg-streamer and although my speeds are faster than yours (20 mb), it should work. What program are you using to stream the video? Also, what resolution are you using?

[AndrewS]

Might be worth experimenting with http://picamera.readthedocs.org/en/rele ... -streaming